This test ejects slots 0 to 4 and goes through the state machine
without creating any errors like FINDA_FLICKERS.
It also verifies the selector parking position is correct for each
ejected filament slot.
Waiting for the selector to return to the parked position after homing
is not enforced by the firmware and should therefore not be enforced by
the unit tests. There are some few exceptions to this, and for those
situations I added a parameter to SimulateSelectorHoming() called
waitForParkedPosition to explicitly wait for the selector to return to
the parked position if set to true. This is very useful when setting up
test cases in general and also allows us to control the behavior in each
test.
Needs to be tweaked further to make it a production code.
But my primary concern now is the fact that it doesn't seem to help too much while homing over the too-tightened Idler cover.
Based on long-term test experience - saves some code + prevents the user from entering hard-to-understand states.
Only Retry remains as the one and only way of recovering from errors.
Several issues addressed in this PR:
- CutFilament tuning + error recovery
- introduce register 0x1d (cut filament selector iRun current level)
- optimize setting iRun and iHold currents in the FW
- CutFilament unit test fixed
The reasons for this change are:
- NoCommand is used during the lifetime of the firmware as a fallback in case an unknown command is received (simplifies command handling code). It must remain not doing anything.
- StartUp became a complex infrastructure which needs to "live" until an error is fixed (if any). That requires a "standard" StateInner() function which waits for the user to resolve the error.
Unit tests renamed as well.
Intended for scenarios when FINDA used to be OFF but accidentally became ON without a reason.
The user is obliged to inspect FINDA and tune its switching.
If FSENSOR_DIDNT_SWITCH_ON was caused by misaligned Idler, rehoming it may fix the issue when auto retrying -> no user intervention.
So first invalidate homing flags as the user may have moved the Idler or Selector accidentally.
Beware: we may run into issues when FINDA or FSensor do not work correctly. Selector may rely on the presumed filament position and actually cut it accidentally when trying to rehome.
It is yet to be seen if something like this can actually happen.
MMU-191
This PR is a different solution to what @gudnimg found in PR#233 / PFW-1404.
The benefit of this approach is the fact, that the button press event is generated when the button is pressed and not after it has been released.
The downside is obvious:
CPUFLASH: +28B
RAM: +1B
ReadResponse unit tests usually takes at least 30 seconds to run on my
computer, so having the unit tests run on more than one thread makes a
big difference.
Guðni Már Gilbert
vintagepc
D.R.racer
Yuri D'Elia
Alex Voinea